The new JTAGICE3 supports faster in-system debug and programmer with full control of all MCU features and configurations. The new design allows the debugger to program the on-chip 256 KB flash AVR ...

As for the other flags used in the programming commands above: When using the Arduino as an ISP programmer you must specify the speed, using ‘-b’. That value is set in the Arduino sketch and should be ...

AVR programmers can be bought for just a few dollars on the Internet, but if you’re building an expansion board with an AVR for your Raspi, this is the build for you. It’s a safe way of programming an ...

The project allows an easy transfer of hex programs to most Atmel AVR microcontrollers without the need for high cost and constraint time. The project allows an easy transfer of hex programs to most ...

Not just for nerds, anyone with an interest in electronics, computers, or engineering can build a circuit to blink an LED or read a temperature sensor. The NerdKit will walk you through building the ...

A new mid range in-circuit debugger and programmer has been unveiled by Atmel. The JTAGICE3 supports all Atmel AVR 8 and 32bit mcus and is said to be smaller, faster, and more robust than the previous ...