DHT11 pin 1 <-> VDD (3.3V) DHT11 pin 2 <-> P0.31 DHT11 pin 3 <-> do not connect DHT11 pin 4 <-> GND There is NO pull-up resistor required, we're using internal nRF52's pullup.

From the Wemos DHT11 shield specs the DATA OUT pin is connected to D4 of the Wemos. Note: Having the shield compact on top of the processor increases the temperature. In normal Mode this can be up to ...

Hi, I'm new to TM4C123G series and I'tm having a lot of trouble to read serial data from a sensor I bought a DHT11 sensor because I need to measure umidity and temperature and its output is a 40bit ...

I had some problems to put DHT11 to communicate with TM4C1294XL launchpad, so I am sharing the code... Its not very polished, but, works, and can be used as base for ...