The CS383’s eight-drive, hot-swappable backplane makes its potential use as a massive network attached storage (NAS) chassis a given, but then there's the rest of the case: NAS systems don’t often ...

A blast from the Elektor archives: this 1998 battery tester uses a simple LED display to reveal a battery’s true condition under load — even below 1 V.

The LED matrix 8x8 is a system of 64 interconnected LEDs that, with the help of the MAX7219 LED driver, light up as programmed, and all of this is located on one board and is truly easy to use. You ...

Abstract: This article introduces a novel deep learning approach, utilizing a seq2seq model, to predict far-field radiation emissions (REs) in high-density, multilayer, and complex printed circuit ...

Build festive decorations using Arduino and Raspberry Pi with these five creative holiday projects and video tutorials ...

Discover how to build a simple wireless power transfer system at home using readily available components like enameled copper wire, an LED, a 2N2222A transistor, and a 9V battery. This step-by-step ...

Need a Hall sensor? A strip of copper, a strong magnet, and an LM358 are all you need to explore the Hall effect hands-on. This experimental setup turns microvolt signals into measurable millivolt ...

[HONG KONG] When Nvidia chief executive officer Jensen Huang hosted a private banquet for suppliers in Taiwan in May, the room was packed with some of the biggest names in global electronics. The ...

Abstract: Since printed circuit board (PCB) is the key to ensure the reliability of electronic equipment. Therefore, defect detection for PCB is a basic and necessary work. This paper proposes a PCB ...